This is still very much a prototype version.
As I had never used a 3D printer before I just used the filament that came with it.
This version was printed to verify that my dimensions were correct.
The support onto the camera lens is there to align the diffuser and also protects the foot of the godox flash.
I have already had to replace one of these in the past as they are made of thin plastic and not very strong.Currently there is a hole and two notches in the support so that a zip tie can be used to hold the diffuser in place. The next version will probably be changed to a velcro strap. The blue section was not intentional, I run out of filament so used what was available to finish the print.

Thank you for looking and for your kind comments.